Description
-
CDS products are single component
-
All-Green Marine Grade coating made in Singapore
-
Designed for heat reduction, waterproofing and corrosion protection
Environmental Requirements
-
Application temperatures:
-
It is not recommended to apply if ambient weather temperature is below 13 ̊C (55 ̊F) or above 38 ̊C (100 ̊F)
-
It is not recommended to apply if surface temperature is below 13 ̊C (55 ̊F) or above 49 ̊C (120 ̊F)
-
-
Dew point not to be lower than -15 ̊C (5 ̊F) of air temperature (Check your local dew point to determine when you should apply. The product will not dry properly and you will have to re-coat)
-
Relative humidity to be below 85%
-
Wind velocity should not exceed 7m/s
-
DO NOT APPLY IN RAIN OR IF RAIN IS EXPECTED TO OCCUR WITHIN 4 HOURS OF PRODUCT DRY TIME
Uses
-
Applies on 99% of substrates to address thermal, corrosion or waterproofing concerns
Surface Preparation
-
Substrate should be clean and dry
-
Clean surface thoroughly using degreaser or detergent to remove any film, scale, loose material, oils or foreign material that will inhibit bonding
-
Wire brush or wire wheel is acceptable to remove any loose rust
DIRECTIONS:
-
Apply only to clean, dry, stable surfaces
-
Apply CDS Defence on rusty steel surfaces to prevent oxidation BEFORE applying CDS Bond
-
Apply first coat of CDS Defence to the prepared surface by roller, brush or spray
-
Apply one complete thin coat and allow to dry for 12 to 24 hrs (depending on the local dew point)
-
Brush or Roll on one thin coat
-
Spray guns and spray tips: Product is thin. Use a small diameter spray tip
-
Spray coatings are recommended to allow the first coat to dry tack free before applying further coatings
WARNINGS:
-
KEEP FROM FREEZING
-
DO NOT THIN OR DILUTE THIS PRODUCT
-
ANY CHANGE TO THE CONTENTS OF THIS CONTAINER WILL VOID WARRANTY • READ PRODUCT DATA SHEET AND MATERIAL SAFETY DATA SHEET PRIOR TO USE
Coverage
-
CDS Defence will typical cover 100m2 to 120m2 per 20L pail depending on substrate surface and thickness of application
Packaging
-
CDS Defence is available in 20L pail
Shelf Life
-
1 year in unopened pail
Storage
-
Store in a cool dry place out of direct sunlight and heat
-
Never allow the product to freeze in liquid form, once applied and cured, CDS Products can withstand any freeze thaw cycle
Health & Safety
-
Inhalation: Remove individual to fresh air, if irritation persists, seek medical attention
-
Skin contact: Flush with water
-
Eye contact: Flush with water for 15 minutes while holding eyelids open
-
Ingestion: Give 2 glasses of water to drink and seek medical attention
-
Note to physician: Inhalation of product mist may cause headache and nausea
Hazards Statements
-
Avoid breathing dust / fume / gas / mist / vapours / spray
-
Contaminated work clothing should not be allowed out of the workplace
-
Wear protective gloves / protective clothing / eye protection / face protection
Precautionary Statements
-
If on skin: Wash with plenty of water and soap
-
If skin irritation or rash occur, get medical advice / attention
-
Take off contaminated clothing and wash before reuse
Disclaimer
The use of this product is beyond the manufacturer’s control and liability is restricted to the replacement of material proven faulty. The manufacturer is not responsible for any loss or damage arising from incorrect usage. Specifications are subjected to changes without prior notice. Before application, customers and users are requested to check with Corrosion Defence Systems Pte Ltd and/or our authorised distributor to verify suitability of application for our products.